Global Technology Associates GBWA200501-01 User Manual download pdf (Page 45)

4 – Troubleshooting 41

Note

Distinguish between crossover cables and straight-through cables

by comparing the connection ends. On a straight-through cable, the

wire order matches; on a crossover cable, the ﬁrst three of the four

wires are in reverse order.

6a. How do I install the parallel port hardware key block?

The parallel port hardware key block must be installed in the parallel (printer)

port. The side to be attached to the port is labeled COMPUTER, with arrows

pointing in the direction of the computer. Screws are provided to connect

the key block securely to the port. If the computer is close to a wall or other

obstacle, you can attach an extension cable to the port, then attach the hard-

ware key block to the cable. Use a straight-through, 25-pin, male-to-female

cable.

If the hardware key block is not recognized once you have booted the

system, and the serial number and activation code are both entered cor-

rectly, make sure that your system’s parallel port is set to the values below.

Hardware Key Block Settings

Mode: EPP, SPP or Both

Address (Hex Value) IRQ

0x378 7

0x278 5

6b. How do I install the USB hardware key block?

USB Key Block

In order to use GB-Ware, you must ﬁrst install the hardware key block.

this after you install GB-Ware, but before conﬁguration.

1. Register your GB-Ware ﬁrewall and retrieve your activation code.

(For more information, see the registration section.)

2. Plug the USB key block in to your GB-Ware ﬁrewall.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

No comments

Global Technology Associates GBWA200501-01 User Manual Page 45